1 рецензия на български за 3DJAKE Resin Tough Black

Strong, but annoying to print with.

Оценено с 3 от 5 звезди.

This resin is an incredibly strong material that delivers impressive durability and resilience. However, while it offers good strength, there are a few significant considerations to keep in mind.

It can be quite challenging to print with. Its high viscosity makes it thick and difficult to handle, requiring patience and extra attention during the printing process. Heating the resin to ~30 degrees C may prove helpful.

Additionally, the exposure times for this resin are remarkably long. Using an Anycubic Photon Mono X printer required a lengthy exposure time of around 14 seconds(!) This can significantly slow down the printing process and test your patience.

Furthermore, curing the tough resin can be time-consuming. In my experience at least a 30 minute cure time is necessary (Anycubic Wash&Cure Plus)

One very important aspect to note is that when washing the printed parts in IPA the resin tends to leave behind a white goo residue. In my experience it was quite difficult to clean and required extensive brushing of the inside of my washing station.

In conclusion, the 3DJake Resin Tough Black is a fantastic choice for projects that demand exceptional strength and impact resistance. However, its difficulties in handling, long exposure times, extended curing period and need for preheating make it a resin better suited for experienced users who are willing to invest the time and effort to master its printing requirements.

Photon Mono X Settings (80% power):
Burn-in layers: 5
Burn-in layer exposure: 60s
Layer thickness: 50um
Light-off delay: 1s
Exposure time: 14.0s
Lift distance: 8mm
Lift speed: 1mm/s
Retract speed: 3mm/s

Беше ли ви от полза тази рецензия? Да (0) Не (0)